browser icon
You are using an insecure version of your web browser. Please update your browser!
Using an outdated browser makes your computer unsafe. For a safer, faster, more enjoyable user experience, please update your browser today or try a newer browser.

current issues

Posted by on July 26, 2012

our old prop eaten by electrolysis

our new prop

As we were sailing up to Cape Cod, there were a few issues that had developed. The port engine is losing about a quart of oil about every 15 hours of run time. The starboard rudder post and drive shaft began making a knocking sound. The wind indicator is hooked on something at the top of the mast. The new main halyard keeps twisting in the 2:1 block system. Which problem did we feel like investigating first?
The other day, Wil put on the swim mask and dove to check the cutless bearings on the starboard side. The cutless bearings seem fine, but there are definitley wobbles in the rudder post and drive shaft. He also was surprised to discover something else. Our zincs on the prop shaft were already significantly pitted. The boat has only been in the water for just less than 4 weeks and there’s already electolysis damage. This means we most likely have excessive electrical current leaking from our grounding system. There is a short or ground fault amidst our many wires running through the boat, and it must be tracked down and fixed immediately. The zincs will only be sacrificial for a limited period of time before the electrical current destroys our props and aluminum rudder housings.
When we were at the boat yard, we had replaced the rudder housing and bearing on the starboard side. The housing was a brand new piece of aluminum that we’d had fabricated. Now, we’re wondering if the quality of aluminum wasn’t up to standard for its purpose. Our electrolysis is bad and it has already destroyed the new starboard rudder housing, hence the rudder wobble. However, the prop shaft wobble is a separate issue.
Yesterday, we started the hunt for the electrical leak. We didn’t get very far before frustration set in. After some additional research, Wil has created a list of possibilities to explore today. This is going to take some time and it won’t be fun.

4 Responses to current issues

Leave a Reply to RobinP Cancel reply

Your email address will not be published.